Skip to content
The Personal Edit — A changing collection ✦Free shipping on every order ✦Every piece measured in cm ✦30-day returns ✦Edited in Kelowna, BC ✦
The Personal Edit — A changing collection ✦Free shipping on every order ✦Every piece measured in cm ✦30-day returns ✦Edited in Kelowna, BC ✦

Measured, not guessed.

A size label alone tells you very little. This page explains how to read the product information we have, compare it with your own clothes and understand what the numbers do—and do not—tell you.

cm ↔ in

The source unit is shown; the other unit is converted using 2.54 cm per inch.

Per piece

Usable charts are item-specific. Missing supplier numbers are never filled in by guesswork.

4 min

Take your three numbers once; re-check after big changes, not after every wash

How to read our charts.

Four habits. They take the mystery out of every table on the site, and they work on any decent chart anywhere else, too.

Ask first: garment or body?

Some charts measure the garment laid flat; some measure the body the garment should fit; a few never say which. We write down what the supplier's data actually declares — and where it declares nothing, we label the chart plainly rather than invent a basis. Compare your three numbers with the chart and the difference tells you the room.

Centimetres first.

A product chart keeps the source unit and shows a conversion where the data can be read. Some listings do not include a complete usable chart. If you think in inches, the calculator below converts without asking you to do the math in your head.

Per piece, never per label.

An M here is not an M there. Suppliers grade differently, cuts vary, and fabrics behave differently. A generic size table cannot answer for every garment. Where a usable chart exists, it belongs to that item; where it does not, the product page says so.

Read the gap.

Chart minus body is the number that matters. How much room can be generous depends entirely on the cut: a columnar coat may run 10cm over your bust and still look sharp, while a fitted knit wants zero. The gap, plus the fabric note on the piece, is the whole decision.

A real one, as it ships.

Below is an actual chart from the shelf right now — pulled live, not typed up for the page. This is the format you'll find across the shop.

Pu Tassel Trench Jacket · $72 · Measurements. Shown in the chart's own centimetres, inches below.
SizeBustLengthShoulder widthSleeve length
S98 cm38.6 in115 cm45.3 in42 cm16.5 in58 cm22.8 in
M102 cm40.2 in116 cm45.7 in43 cm16.9 in59 cm23.2 in
L106 cm41.7 in117 cm46.1 in44 cm17.3 in60 cm23.6 in
XL110 cm43.3 in118 cm46.5 in45 cm17.7 in61 cm24 in

Measurements — the supplier's table doesn't say which of the two the numbers are, so we don't either. Compare with something you already own.

If a garment's chest is 98 and yours is 92, you have six centimetres of difference to distribute — the cut decides whether that reads sharp or tight. That judgement, with the piece's own chart, is how the right size gets chosen.

Open the piece

Your three numbers, in four minutes.

A soft tape, a mirror, a thin layer. One pass, three useful reference numbers.

Take three.

Stand relaxed, arms down, in a thin top. Bust, across the fullest part, tape level under the arms and across your back. Waist, at the narrowest point of your torso, usually just above the navel. Hip, around the fullest part of your seat, feet together.

A yellow tape measure and a handwritten set of centimetres beside a folded knit
Your three numbers, somewhere findable.

Snug, not squeezed.

The tape should touch your body everywhere but indent nothing. Breathe out normally before you read the bust and the waist — flexing or holding your breath only cheats the chart you're about to trust. A mirror keeps the tape level.

A mirror detail of a woman in a cream knit checking her posture
Mirror check: level tape, normal breath. Studio imagery, created by WezelBezel with AI.

Converting your numbers

cm ÷ 2.54 = in

Centimetres are the chart's native tongue; the calculator below flips both ways

Compare, then order.

Lay a piece that already fits you flat and measure it the way a chart asks you to — that's a garment read. Compare with your three body numbers, forgive the cut for the room it asks, and only then order. If the numbers disagree in person, 30 days, unworn, back to us.

Brand film · laying a cardigan flat to measure it. Illustrative imagery.

Now run yours.

Adding a chart value from any piece converts it and shows you the room. It won't choose a size for you — the piece's own chart travels with it.

Measure yourself

Bust

Around the fullest part of your chest, tape level across your back and under the arms. Breathe out normally.

Enter a number to convert it.

Waist

Around your natural waist, the narrowest part of your torso, usually just above the navel. Snug, not squeezed.

Enter a number to convert it.

Hip

Around the fullest part of your hips and seat, feet together, tape parallel to the floor.

Enter a number to convert it.

Add a chart value from any piece to see how much room it has compared with your body. This tool converts and compares. It won’t choose a size without the piece’s own chart.

Find a piece

Four minutes once. Every chart after that reads itself.